Forum | Classifieds | Lost & Found | CGKA | Industry | Sensors | Forecast | Spots | Seattle | Decals | RSS | Facebook Events | Photos | Search | Register | Profile | Log in to check your messages | Log in  Shortening a Rev bar          Northwest Kiteboarding -> Gorge / Portland / Oregon Coast previous topic :: next topic   Author Message Bailey Since 13 Apr 2008 87 Posts   Mon Sep 15, 08 4:44 pm    Shortening a Rev bar Do I just take the screw out of the end piece or is it glue on. Kataku2k3 Since 14 Aug 2005 3754 Posts PDX-LA Videographer Mon Sep 15, 08 6:45 pm     The bar ends are semi-glued on, but if you take out the screws, then rotate/wiggle the ends, it'll break the glue. When reinstalling the ends, I normally glue them on first, then once the epoxy has dried, drill holes for the screws. We haven't tried anything smaller than 14" with the REVs, so be careful! EDIT: My spelling was fuck'd! Last edited by Kataku2k3 on Mon Sep 15, 08 9:39 pm; edited 1 time in total Bailey Since 13 Apr 2008 87 Posts   Mon Sep 15, 08 7:06 pm     Thanks I have a 7m and 9m rev and the 7m is a bit fast and I lose the kite in my rotations and the 9m is so sweet I would like to slow the 7m down a bit, I was going to shorten it by 2 inches        Northwest Kiteboarding -> Gorge / Portland / Oregon Coast All times are GMT - 8 Hours Page 1 of 1   Jump to: Select a forum Northwest Kiteboarding Discussion Forum----------------Gorge / Portland / Oregon CoastFor SaleLost & FoundIndustry SoapboxCGKA  You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You can attach files in this forum You can download files in this forum