|
previous topic :: next topic |
| Author |
Message |
corey4x4man
Since 13 Jun 2011
134 Posts
Beaverton, OR
Stoked
|
 Fri May 25, 12 7:12 am all foot pad screws the same? |
 |
|
I recently picked up a new F-one board but when I received it the the foot pad screws were missing as well as the screws for the handle....
SO my question is are all the screws the same thread pattern or do o need to find an reseller to find the correct screws?
P.S. -I am hoping to ride it today and have already contacted the person I bought it from but they are in Hood river I am in portland.... |
|
|
Kataku2k3
Since 14 Aug 2005
3753 Posts
Los Angeles, CA
Videographer
|
| Fri May 25, 12 7:21 am |
|
|
| Not sure for that specific board, but most manufactures use 1/4-20 or M6 inserts. At this point, it's probably easier to swing by a decent hardware store if you're in a rush. Parkrose Hardware is a little spendy, but it's the only place I usually buy shit due to their huge selection of stainless! |
|
|
Wind Slither
Since 04 Mar 2005
2622 Posts
The 503
METAL
|
| Fri May 25, 12 7:22 am |
|
|
| There not all the same but you should be able to find replacements at a good hareward store if they have a good selection of stainless. |
|
|
Sasquatch
Since 09 Mar 2005
2102 Posts
PNW
Bigfoot
|
| Fri May 25, 12 7:39 am get stainless |
|
|
| Wind Slither wrote: | | good selection of stainless. |
Ya, make sure you get stainless and as long as you are there, might as well get two sets. That is what I do anyways. |
|
|
Nak
Since 19 May 2005
4304 Posts
Camas
Site Lackey
CGKA Member
|
| Fri May 25, 12 8:16 am |
|
|
| Kataku2k3 wrote: | | Parkrose Hardware is a little spendy, but it's the only place I usually buy shit due to their huge selection of stainless! |
Parkrose Hardware  It's amazing all the stuff they've got there. Best hardware store period. There's one in Vancouver too. |
|
|
corey4x4man
Since 13 Jun 2011
134 Posts
Beaverton, OR
Stoked
|
| Fri May 25, 12 11:10 am |
|
|
| They were 6m. Ace hardware had what I needed! |
|
|
undertow
Since 15 Feb 2008
371 Posts
BeaversBurg
Obsessed
|
| Fri May 25, 12 12:26 pm |
|
|
just bought a new F-One 12 Trax Freestyle and lost one of the bolts, tried to use some I had for an Ocean Rodeo board but they were too long. Went to Windance in HR and dug through the Miscellaneous kite bolt drawer and found one.  |
|
|
|
